Microscan MS-Q Imager Instrukcja Użytkownika Pobierz pdf (Strona 42)

Performing a Hardware Default

Save changes whenever you reconfigure Imager settings.

Save

Settings

Clear

all Data

Default

to USB

Clear XML

Rules

Default

to PS2

6. Press and hold down the Imager’s left and right top buttons while reinserting the

cable into the bottom of the handle attachment.

7. When the cable is fully inserted, the Imager will

beep five times. The left indicator LED will be

RED and the right indicator LED will be GREEN.

8. Press and hold down both the left and right top

buttons until the left indicator LED switches off.

The Imager will then cycle through several different LED patterns and emit

two

beeps.

This indicates that the Imager is in its default mode and is ready for use. Be

sure that the Imager’s memory is clear before you return to your desired settings. The

following symbols will allow you to clear the Imager’s memory of commands, settings,

XML rules, and other data:

Clear XML Rules

Clear Memory

For the default process to work correctly, you

must release both buttons as soon as the left

indicator LED switches off.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 203 204

Brak uwag

Microscan MS-Q Imager Instrukcja Użytkownika Strona 42