Microscan QX Hawk Instrukcja Użytkownika Pobierz pdf (Strona 206)

100

101

5-108 QX Hawk Industrial Imager User Manual

I/O Parameters

Serial Verification

Allows the user to verify configuration command status.

Serial Command Echo Status

This command is useful in removing any doubt about the imager’s interpretation of any

configuration command.

For example, if the current preamble is “SOM” and <K141,1,START> is entered, the

imager will echo back <K141,SOM> since the attempted entry “START” exceeds the four

character limit for that command. Therefore, it is rejected and the existing “SOM” message is

echoed back and remains the preamble message.

When enabled, a configuration command received from the

host is echoed back to the host with the resultant settings.

If a command with multiple fields is processed, some of the

fields may have been processed properly while others were

not. The changes will appear in the string echoed back so that the user will know which

fields did or did not change.

Serial Command Beep Status

Used to audibly verify the acceptance and validity of a command.

Causes the imager to beep once whenever a K command is entered to indicate that the

command was accepted and processed.

If an invalid command is entered, the imager beeps 5 times to indicate an invalid entry.

However, this does not necessarily mean that all data fields have been entered incorrectly.

Only one bad field needs to be found in order to activate the 5 beep response.

Imager

Host

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 459 460

Komentarze do niniejszej Instrukcji

Brak uwag

Microscan QX Hawk Instrukcja Użytkownika Strona 206

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czytniki kodów kreskowych Microscan QX Hawk