Microscan QX Hawk Instrukcja Użytkownika Pobierz pdf (Strona 329)

100

101

QX Hawk Industrial Imager User Manual A-13

Appendices

QX-1 Connectors

Connector T on the QX-1 Interface Device is the Trigger connector.

Connectors 1, 2, and 3 can be used to bus power and data as required by the application.

The connectors on the QX-1 interface device physically mirror those on the QX Hawk imager,

but they do not have explicit pin assignments. The QX-1 connectors take on the communications

and power roles that are assigned to them.

Connectors 1 and 3 are 12-pin plugs, and Connector 2 is a 12-pin socket. All three

connectors can be assigned to bus power and data.

The two switches at the center of the device allow the user to route signals as needed.

The simple diagram above (also shown on the base of the QX-1) illustrates how power,

communications, I/O, and trigger signal can be routed through the QX-1 device.

Power can be bussed between imagers and interface devices. At each location on a

network where a new power supply is added, the Power switch on the QX-1 can be

used to break power between Connector 2 and Connectors 1, 3, and T.

The Trigger signal between Connector 2 and Connectors 1, 3, and T can be broken

using the Trigger switch. This isolates trigger signals as required.

+10-28V

Trigger

Ground

Trigger/New Master / Input 1 Common

QX-1 Trigger Connector

4-pin Socket

1 +10-28V

Trigger / New Master /

Input 1 Common

3 Ground

4 Trigger

QX-1 Wiring Diagram

Power Switch

Trigger Switch

1 2 ... 324 325 326 327 328 329 330 331 332 333 334 ... 459 460

Komentarze do niniejszej Instrukcji

Brak uwag

Microscan QX Hawk Instrukcja Użytkownika Strona 329

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Czytniki kodów kreskowych Microscan QX Hawk