
Device Control
17-12 MS-880 Industrial Long Range Scanner User’s Manual
17–Utilities
Device Control
You can control laser scanning by ESP or serial command.
By ESP
You can access Device Control from the Utilities menu.
For any of the Device Control commands, right-click on the command and make
your selection.
By Serial Command
Enable Laser Scanning
Sending <H> will turn the laser on continuously.
Note: Enable Laser Scanning does not relate to Laser On/Off command.
Disable Laser Scanning
Sending <I> will turn the laser off. This feature is useful during extended periods of
time when no bar code labels are being scanned or the scanner is being configured.
Disabling laser scanning will not affect any downloaded commands to the scanner.
Note: Disable Laser Scanning does not relate to Laser On/Off, which when
enabled also turns off the laser but only between read cycles.
Motor On
Sending <KE> turns the spinning mirror and raster mirror motors on (if not already
running).
Note: the spinning mirror reaches full speed after a short time delay.
Motor Off
Sending <KF> turns the spinning mirror motor off. This command is useful for long
idle periods.
Note: Laser turns off whenever motor is off.
Komentarze do niniejszej Instrukcji